Thursday, February 28, 2013

Mass, Volume And Density

The purpose of this experiment is to understand the uses and functions of various devices used to have got the most common units of footstepment in physics for mass, hoi polloi and density. We were given a steel ball, a rectangular aluminium block, a brass cylinder and an aluminum annular cylinder to be measuring rodd by a vernier caliper, micrometer gauge and weight balance. We learned the uses of the equipment and the values given through measure to obtain the significant figures needed for accuracy. In this experiment, we exit accept the middling of 5 measurements to produce a value of not bad(p) accuracy in which we will use for our final answer. We will and so compare it with the given value provided in our natural philosophy Labs manual.
The purpose of this experiment is to familiarize ourselves with canonical measurement tools. It is also to learn how to use the concepts of the significant figures, the observational uncertainty (error) and some methods of error and data analysis in our experimental measurements.

Procedure/Raw data:
A. Steel clod:
The diameter (D) was measured using a micrometer. Once the diameter was obtained, it was used it in the formula (1/6)*?*D3 to obtain the tidy sum (V). I then calculated the intermediate of the leger (v av.).

Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!

This average was subtracted from all(prenominal) volume to obtain a mean difference of volume (|dvi|) for each measurement, which was then averaged. A balance was used to measure the mass (m). The mass was then divided by the volume to obtain the density (?) of the steel ball. This was done for all 5 measurements to obtain an average density (? av.). The average density was then subtracted from the density of each to obtain a mean deviation of density (|dpi|) which was then averaged.
The average density was compared with the accepted average density (7.8*103 kg/m3) provided in the labs manual. I then calculated the percent % error by converting my average density from grams per millimeter cubed to kilograms per meter cubed then taking the sheer(a) value of...If you want to get a full essay, order of magnitude it on our website: Ordercustompaper.com



If you want to get a full essay, wisit our page: write my paper

No comments:

Post a Comment